Navigation

  • Page 1

    Page 1 Power off during tool change Condition 1 Step 1 Make sure emergency switch is off. Step 2 Put a paper board or cushion on table. Paper board Emergency switch

  • Page 2

    Page 2 Step 3 Have Person A climb up magazine. Pull lever left to release brake. Step 4 Use 12mm socket wrench and turn counterclockwise until the arm turns. Warning: make sure the arm swing back to Home Position away from tool (be careful, tool might drop). Have Person B on ground watch for...

  • Page 3

    Page 3 Arm must be perpendicular to operator. After one light remains, Person A needs to make sure to pull lever right, back to original position. Step 5 Push Shift key and exit control. Turn power off (Red push button). Step 6 Restart machine. Release emergency switch. Press “SERVO R...

  • Page 4

    Page 4 Step 7 Remove tool from magazine with tool from tool box. Tool magazine needs to be retooled.

  • Page 5

    Page 5 Condition 2 Step 1 Make sure emergency switch is off. Step 2 Put a paper board or cushion on table. Paper board Emergency switch

  • Page 6

    Page 6 Step 3 Clear both tools by releasing the tool release pin and tool lock from arm. Step 4 Have Person A climb up magazine. Pull lever left to release brake. Tool release pin Tool engaged lock Motor brake lever 12 mm socket wrench

  • Page 7

    Page 7 Step 5 Use 12mm socket wrench and turn clockwise until the arm turns (be careful, tool might drop). Have Person B on ground watch for three lights on magazine acrylic plate. Give signal to Person A to stop turning until only one center light remains. Arm must be perpendicular to o...

  • Page 8

    Page 8 After one light remains, Person A needs to make sure to pull lever right, back to original position. Step 6 Push Shift key and exit control. Turn power off (Red push button). Step 7 Restart machine. Release emergency switch. Press “SERVO RESET”, tool will pop up automatically....

x