Navigation

  • Page 1

    PROCEDURE TO SET UP BEDMILL 1454 1. Set up leveling pad, screws (total 6 pieces), and leveling machine. 2. Remove the 3 M8 screw on the bracket on the X-axis (facing machine’s right hand side) from back.

  • Page 2

    3. Remove the 4 screws on the back cover. Loose the 2 locks on both end of the double nut clamper. Twist the center to remove the clamper. Then take out the hook attached to the counter weight inside column. 4. Install the control with 2 screws and 1 adjust-able nut. Plug in 1. Start/Stop Pus...

  • Page 3

    5. Hook up 3 phase power 230V or 460V as pre-wired by customer request and 110V single phase control power source. 6. Release Emergency Stop button. Toggle function switch to “Man”. Turn on spindle Forward/Reverse Switch. Check spindle rotation. Make sure it is correct. If opposi...

  • Page 4

    7. Turn on console power. After boot up, press “F10”. Then press “ENTER”. Release Emer-gency push button and push Servo Reset. (See Fig. 1 & 2) Put in feed mode (See Fig. 3) and set override to 10% (See Fig. 4). Next press “Z+” (See Fig. 5) and slowly move the Z up. Remove t...

  • Page 5

    8. Assemble the way cover, head cover and coolant pipe. (Make sure the left & right way cover is put on the machine correctly)! Fig. 5 Fig. 6 Fig. 7

  • Page 6

    11. “Home” machine before running rapid mode and programming (See Fig. 8). Z move first, Y move second, X move third. Fig. 8 9. Press “X+” and “X-” and slowly move the X left and right to make sure X movement is ok. 10. Press “Y+” and “Y-” and slowly move the Y left and right...

  • Page 7

    12. Test MPG (Manual Pulse Generator). Turn on MPG on X. The screen “Handwhl” will ac-tivate. (See Fig. 7) Turn incremental selector x1, x10, x100 to test 0.0001”/ 0.001”/0.01” in-cremental move. Do as above on Y, Z move-ment test. Incremental Selector Fig. 7 13. Reset spindle and c...

  • Page 8

    Screen will show “Servo off !” (See Fig. 9) 2) Toggle spindle For-ward/Reverse Switch to neutral; then switch to forward or reverse, spin-dle is turning. 3) Push Emergency stop & release one time then push Servo Reset. The handwheel should lock, to function CNC mode. Fig. 9 14. Manual ...

  • Page 9

    The handwheel should lock, to function CNC mode. 15. Start & Stop Push Button Test Press X hard key (See Fig. 11) Press Start then Stop, to test. Fig. 11 16. Auto Lube Check Please fill in the #2 Way Oil. Then turn on Servo. The Auto Lube indicator light is on. (See Fig. 12) This shows t...

  • Page 10

x