Navigation

  • Page 1

    CNC machine safety operationThis manual describes aware of safety considerations engravingmachine when using it, please read the manual carefully to avoidpersonal injury and damage to the machine.First, CNC engraving machines use basic precautionsl. Machine should be fixed on a stable ground, adj...

  • Page 2

    such as the machine does not start for a long time, can be manually eachpart of the lubrication; After adding the oil slowly back and forth, toensure lubrication oil can be uniformly applied to the rail and screw.2. Due to low temperatures, can be both the rail and screw add oil, plusthe best ant...

  • Page 3

    accordance with the engraving depth, the workpiece and the jig isinterference, to meet the above conditions try to get short.12. Prior to processing must be correct definition of X, Y, Z axis from theknife point. After replacing the tool, you must immediately redefined Zaxis from the knife point,...

  • Page 4

    by hand, others use must consent.8. Its prohibited on the beam and put the machine baffle anything to avoidfalling injury.9. During operation on the machine is prohibited lie, but not allowed tosit or lean on the machine frame.Fourth, note after the work1. Remove the chips, clean the machine, kee...

  • Page 5

    2.Spindle mounted on the machine must have security guards, orhigh-speed rotating components may be injury the human body.3.The electro-spindle high-speed rotation of the process do not makecontact with the rotating part of the spindle arm, otherwise it will causeinjury.4. Spindle operators do no...

  • Page 6

    Thank you for purchasing BCAMCNC productsWebsite:actionURI(http://www.bcamgroup.com):www.bcamgroup.comactionURI(http://www.bcamcnc.com):www.bcamcnc.comactionURI(http://www.bcamlaser.com):www.bcamlaser.comService email: actionURI(mailto:service@bcamcnc.com):service@bcamgroup.comactionURI(mailto:Se...

  • Abstract

    such as the machine does not start for a long time, can be manually eachpart of the lubrication; After adding the oil slowly back and forth, toensure lubrication oil can be uniformly applied to the rail and screw.2. Due to low temperatures, can be both the rail and screw add oil, plusthe best antifreeze oil. Twice a month refueling cycle3. Before the process of engraving must check that the spindle coolingand lubrication systems (oil pump) is working properly or not.4.The tool used should be consistent with the specifications of themachine allows, about seriously damaged the tool should replaced.5. Don’t stay the tool inside machine.6.After the tool installed should be test cut one or two times.7. Check the working status of the clamping chuck.8.Workpiece clamping, must follow the "real loaded, installed flat, fittedpositive" principle, is prohibited on the suspended material sculpture, inorder to prevent deformation of the material, the thickness of the materialthan the depth of the large sculpture of 2mm or more.9. In the chucking head rake shall card debris clean.10.The tool installed card, the card must first head screwed into the locknut being put together fitted to the motor shaft, then the tool is insertedinto the first card, and then use the lock nut on the blade wrench slowly,handling tools , elastic nut disable push-pull method, use rotation mode.11.The length of the tool head is exposed card must be decided jointly in

x