Navigation

  • Page 1

    CNC machine safety operationThis manual describes aware of safety considerations engravingmachine when using it, please read the manual carefully to avoidpersonal injury and damage to the machine.First, CNC engraving machines use basic precautionsl. Machine should be fixed on a stable ground, adj...

  • Page 2

    such as the machine does not start for a long time, can be manually eachpart of the lubrication; After adding the oil slowly back and forth, toensure lubrication oil can be uniformly applied to the rail and screw.2. Due to low temperatures, can be both the rail and screw add oil, plusthe best ant...

  • Page 3

    accordance with the engraving depth, the workpiece and the jig isinterference, to meet the above conditions try to get short.12. Prior to processing must be correct definition of X, Y, Z axis from theknife point. After replacing the tool, you must immediately redefined Zaxis from the knife point,...

  • Page 4

    by hand, others use must consent.8. Its prohibited on the beam and put the machine baffle anything to avoidfalling injury.9. During operation on the machine is prohibited lie, but not allowed tosit or lean on the machine frame.Fourth, note after the work1. Remove the chips, clean the machine, kee...

  • Page 5

    2.Spindle mounted on the machine must have security guards, orhigh-speed rotating components may be injury the human body.3.The electro-spindle high-speed rotation of the process do not makecontact with the rotating part of the spindle arm, otherwise it will causeinjury.4. Spindle operators do no...

  • Page 6

    Thank you for purchasing BCAMCNC productsWebsite:actionURI(http://www.bcamgroup.com):www.bcamgroup.comactionURI(http://www.bcamcnc.com):www.bcamcnc.comactionURI(http://www.bcamlaser.com):www.bcamlaser.comService email: actionURI(mailto:service@bcamcnc.com):service@bcamgroup.comactionURI(mailto:Se...

  • Abstract

    accordance with the engraving depth, the workpiece and the jig isinterference, to meet the above conditions try to get short.12. Prior to processing must be correct definition of X, Y, Z axis from theknife point. After replacing the tool, you must immediately redefined Zaxis from the knife point, X, Y-axis from the knife point can not bechanged.13. Do not spindle rotate when make tool sensor, prohibited on the knifeto water, oiling, the knife would have to cover the cup when not in use.14. Before the start of the processing (the knife), shall put hand on the redemergency switch button at one accident situation immediately press.Third, the process of security precautions1. Prohibits touch the tip and iron, iron must use a brush to clean.2. Prohibit contact with your hands or any other means is rotating spindle,workpiece or other moving parts.3.Prohibition-process measurement of the workpiece, the speed, but cannot wipe the piece with cotton yarn, can not clean the machine.4. Operation of the machine, the operator may not leave their postsimmediately stop the machine abnormal phenomenon.5.Always check the bearing temperature is too high should find therelevant personnel.6. During the process, not allowed to open the machine guard doors.7. Strict compliance with personal responsibility, the use of the machine

x