Navigation

  • Page 1

    CNC-1240 INSTALLATION & SET-UP SET-UP CLEARANCES & CONDITIONS When considering the permanent location for your SmithyCNC bed mill the following should be taken into consideration: The machine should be installed on a flat surface so that the machine does not rock or slide during operation...

  • Page 2

    Power Requirements 220 Plug Configuration The power cord/plug that is supplied with the SmithyCNC EZ-Trol System and SmithyCNC PC Control option is a 220 volt NEMA 6- 15P plug. This plug will fit into a 220 volt NEMA 6-15R or 6-20R receptacle. NOTE: Smithy recommends that you run your machine on ...

  • Page 3

    Step 3: Make sure your stand's feet or leveling pads are touching the ground at the same time. If not, adjust the feet to make sure the machine stand does not physically rock.Step 4: Once all the feet or leveling pads are touching the ground and the machine is not rocking, adjust the middle two f...

  • Page 4

    Installation & Set-up Figure 4.10 Engine Hoist Spreader correctly positioned for lifting SmithyCNC Mill Step 8: Now that the machine is relatively level, raise the machine so that it is hovering, no more then 6-10 inches, over the machine stand. Step 9: Using a straight rod (all-thread works ...

  • Page 5

  • Page 6

    SmithyCNC 1240 Operator’s Manual Using an engine hoist to remove the machine from the pallet Figure 14.12 Lifting with an engine hoist Step 1: Using an engine hoist requires 2, 6 feet pieces of chain and 4 clevis pins large enough to attach the links of the chain that you are using together. Re...

  • Page 7

  • Page 8

    Installation & Set-up Step 8: Attach the hoist spreader to the arm of the engine hoist if you have not done so already, and slowly raise the machine from the pallet. Check to make sure that the machine is relatively balanced between the front and back of the machine. If it is leaning too far ...

  • Page 9

    Now that your machine has been set-up, you are ready to install your control system. If you purchased a SmithyCNC EZ-Trol system or PC Ready System, please refer to the documentation sent with your control. If you have purchased the base machine, we have supplied you with the a set plugs that mat...

x