Navigation

  • Page 1

    2.34. Tail Stock (Servo Driven) Tail Stock servo system (B-axis) specification. Thrust status sensor(SX74) Servo motor (B-axis) 2.34.1 Tail Stock operation 1) Tail stock operation mode Tail stock is controlled by servo motor. The axis name is B-ax...

  • Page 2

    ⑤ Auto feed traverse - B-axis can be traversed by "G01 Bxxx.xxx Fxxx.xxx" command in auto mode. - Traverse speed override has 10% steps from 0% to 200%. The maximum speed is 1000 mm/min. - Incremental command is not valid. ⑥ Auto rapid traverse. ...

  • Page 3

    Tail stock is moved to chuck side with commanded thrust by pressing tail stock foot switch. If the foot switch is taken off, tail stock is stopped and thrust is activated. Although foot switch is taken off without workpiece support, tail stock is stopped on the thrust...

  • Page 4

    4) Servo Driven tail stock power setting screen ① Search screen ▶ Press "CUSTOM1” on MDI keyboard. ▶ Press " 9. TAIL-S" ② Thrust setting There are soft buttons (100kgf~800kgf) on the bottom of "Tail Stock Thrus...

  • Page 5

    ③ Status display B-axis position is displayed during tail stock is traversed with thrust. “THRUST” marking is changed from "NG” to “OK” and X12.7 is changed from "on" to "off" after tail stock support the workpiece. If SX74 is ...

x