Navigation

  • Page 1

    A Company of ThyssenKrupp Technologies Fadal Machining Centers DUAL ARM TOOL CHANGER Error Messages ATC AMBIGUOUS TURRET POSITION, VERIFY POCKET # WITH SETTO,# or, TURRET LOCATION LOST, RESET TURRET LOCATIONS WITH SETTO,# The Tool Count sensor indicates the Turret is located between Buckets, o...

  • Page 2

    ATC BUCKET DOWN SOLENOID/SENSOR FAILURE or, BUCKET DID NOT MOVE DOWN The Tool Down Sensor has not reported a successful move down of the Bucket in preparation for exchanging the tools. 1. Check the upper reed switch on the Bucket Cylinder. 2. Check for inadequate air supply. 3. Check air valve. ...

  • Page 3

    2. Check Head Position Sensor and Head position. 3. Check for power interruption to Arm Motor, fuses, and circuit breakers. 4. Check for proper Spindle orientation. 5. Check for Tool alignment in ATC Grippers. CAROUSEL SOLENOID FAILURE (OR SENSOR) or, TURRET HAS NOT ROTATED The Tool Count Sensor...

  • Page 4

    2. From the <Enter Next Command> line, type SETTO. 3. All of the Tool numbers will be reset to that of the Bucket numbers. Tool number 1 is in the Spindle. 4. Check the table in DD. 5. If Turret rotates in the incorrect direction, the Turret Motor may need to be re-phased. SETTO,# SETTO...

  • Page 5

    Operating the DATC from a Program The commands used within a program to operate the Dual Arm Tool Changer are the same codes as the Geneva and Servo-Turret toolchangers. The call for a toolchange can take advantage of the ability of the DATC to pre-stage the next tool into the Bucket Ready posit...

x