Navigation

  • Page 1

    DESIGN OF THE ANGLE PLATEThe angle plate attachment for the Sherline mill wasdesigned with help and many suggestions from GrahamTaylor of Livonia, Michigan. The multiple hole patternallows the rotary table or mill vise to be attached directlyto the table. Also included is a 3/4-16 adaptor whichat...

  • Page 2

    FIGURE 3a & 3b (Above)—Mounting pointsfor the mill vise.FIGURE 4—Mountingpoints for the 2.5” 4-jawchuck.FIGURE 5—Mountingpoints for the 3.1” 4-jawchuck.FIGURE 6—Using a Tommy Bar to keep a 3-jaw chuck fromunscrewing during machining. Place the Tommy Bar in oneof the holes in the u...

x