Navigation

  • Page 1

    HD Settings High/Low Speeds and Step distances (From main screen, hit ‘Stop/Cancel’) High: 1000 Low: 100 XY Step: 0.005 Z Step: 0.002 Note: These numbers can vary. *All following settings will be under ‘MENU’ and worded/abbreviated as you would see on screen. Note: All settin...

  • Page 2

    X Axis: 0.079 Y Axis: 0.079 Z Axis: -0.079 Spindle setting Spindle gear set *Spin status no. 7 Spin on/off delay Spindle delay time (ms) 5000.000 Spin initial gear *Spindle initial gear 6 Max spin speed *Max spindle speed (r/min) 18000 Stop spindle ...

  • Page 3

    Y: 0.000 Z: 0.000 Offset setting Public offset Public offset X: 0.000 Y: 0.000 Z: 0.000 Workpiece offset G54 > G59 will correspond to offsets 1 – 6 on main screen. Coords will be distance from home position. Tool change param (N/A) Tool maga capa *Tool...

  • Page 4

    Z max speed Z max speed (inch/min) 225.000 Z dir speed Speed enable Whether to use Z direction speed NO Z direction speed Z direction speed (inch/min) 50.000 Lubrication set Start Auto Lubri Whether to open auto lubrication NO Time interval Tm inte...

  • Page 5

    * Shape separate processing_valid NO Bottom machining * Bottom machining valid NO Metric size * Use metric size NO Eng param Tool lifting ht * Tool lifting height (inch) 0.039 Tool change cue * Tool change cue YES Cyc time * Cyc time_of_eng processing 1...

  • Page 6

    Ref length Limit of short lines 0.100 Path smooth time Path smoothing time (s) 0.000 Feedrate Feedrate 1.0 G code ld config (override speed on/off) G code ld attri Scr F NO *NO for programmed speeds Scr S NO *YES for override speeds Proc time range File select...

  • Page 7

    Whether to use IJK inchement YES Recycle settings Recycle mach on Whether to use recycle machining NO Recycle times Recycle times 2 Recycle interval (ms) 0 Stop spin WT to stop spin when recycle NO Stop spin at end WT to stop spin at end YES Eng unit ...

  • Page 8

    English Delete param bak (Will delete backup.) ADVANCED CONFIG Stalling set Stalling way After processing Keep still Stalling position Workpiece origin Stalling position Enter position Stalling position X 0.000 Y 0.000 Z -0.039 Select position ...

  • Page 9

    Self check input (No settings.) Check output (No settings.) System info Software version NK105_04_37_102 Board card no #### - #### - #### - #### Remaining time Perpetuity Registered times 1 Keystroke diagn (Will check if buttons work.) System upgrade A...

x