Navigation

  • Page 1

    Power On PC.Power On Controller.PC Boots?Press Power On forPC.Is Boot ControllerSoftware attemptingto connect?Open BootControllerProgram.Wait forConnection.NoPress Power On ForController.Boot StrapControllerAwaiting Mode?SelectMode-NormalControllerConnects?Techno Interface StartsAutomatically.See...

  • Page 2

    Use the mouse and Left Click ondirectional Arrow, to move the machine.Does MachineMove?Is a Jog modeselected?Machine Jogscorrectly.Left click on thebox beside the Jogmode you require.Is there anError Message on the screen?Click Reset Errorsto Remove Error.HandWheel:Use switch on theHandwheel ctrl...

  • Page 3

    Jog Machine to X-Y-Zlocation on the table.Techno HDS: Setting OriginJog the machine to where theOrigin will stored.Click the ORI SET button on thescreen.Enter the Origin number (1 to 5,)you want to save and enter 0 intothe X-Y and Z boxes.Is the CorrectTool Number withoffset displayed.Displayed?...

  • Page 4

    This will activate anOrigin/Working Coordinate.Techno HDS:Recalling/Activating OriginWas an OriginSaved previously?Save an Origin as perJTFC0002 .Is there a ToolNumber with offsetdisplayed? ieT.Offset [ T1.1 ]Identify Tool In Chuck. In Tools,Click on the Tool Number that isloaded. eg T3.3 should ...

  • Page 5

    Learning Tool Lengths will record the different Tools Zoffset so multiple tools can be used in a G-code file.JTFC0005Techno HDS: Learning Tool LengthsAre ToolLocationsLearned?Learn tool Locations as perJTFC0007Is the Tool to belearned identified?Go into the Tool Menu:If the tool is in the chuck, ...

  • Page 6

    HDS controller will accept files with any extension, but the files name length cannot exceed 8 characters andfor clarity .ncd is the preferred file extension. The files must be copied onto thePLC drive. There is a foldercalled G-code Files or Programs on the desktop that the files must be dragged...

x