Navigation

  • Page 1

    Tel: 516/328-3970 · Web: http://www.technocnc.com · E-mail support@technocnc.com1HTT00000000Squaring HD/HDS machine.This document will detail how to square a Techno HD/HDS machine. To preform this task you will need:-A set of metric allen wrentches. -A precision square. -A mallet. -A ...

  • Page 2

    Tel: 516/328-3970 · Web: http://www.technocnc.com · E-mail support@technocnc.com2JT00013Squaring HD/HDS machine.Indicating The Precision SquareStep 1: Fix the dial indicator to the Z-Axis.Step 2: Place the precision square onto the exactcenter of the table surface. The squareshould be...

  • Page 3

    Tel: 516/328-3970 · Web: http://www.technocnc.com · E-mail support@technocnc.com3HTT00000000Squaring HD/HDS machine.Indicating the X-Axis to the Y-AxisStep 1: Turn the Indicator so that you can read the dial, making sure that the pin is running along the end of the Precision square. S...

  • Page 4

    Tel: 516/328-3970 · Web: http://www.technocnc.com · E-mail support@technocnc.com4JT00013Squaring HD/HDS machine.Adjusting the Machine. Disable power to the machine and remove the side panels from the Y axis motors, so that the Y-axis motors are exposed as above. Loosen, but do not tak...

  • Page 5

    Tel: 516/328-3970 · Web: http://www.technocnc.com · E-mail support@technocnc.com5HTT00000000Squaring HD/HDS machine.Remove the yellow cover from both sides of the machine. This will allow acces to the upright screws that attach to the bearing carriages.

  • Page 6

    Tel: 516/328-3970 · Web: http://www.technocnc.com · E-mail support@technocnc.com6JT00013Squaring HD/HDS machine.Loosen the 8 screws that hold the uprights to the bearing carriages. Do not loosen the screws completely Keep slight tension on the lock washers,so that you do not tip, the ...

  • Page 7

    Tel: 516/328-3970 · Web: http://www.technocnc.com · E-mail support@technocnc.com7HTT00000000Squaring HD/HDS machine.Using a rubber mallet lightly tap the gantry in the direction the machine needs adjustment. Once there is little or no movement in the dial indicator when the X-axis is ...

  • Page 8

    Tel: 516/328-3970 · Web: http://www.technocnc.com · E-mail support@technocnc.com8JT00013Squaring HD/HDS machine.Engage pinion to the racks on both sides of the gantry and tight-en all the screws. The machine should now be square.

x